not-front-rule

injector torque

Welcome to the Mercedes-Benz Club of America Forums
Here, you'll find members en masse who can talk, guide, answer or listen to your Mercedes-Benz related questions and comments. Participation in the forums is free to Club members. If you're a guest of this site, you'll have access to our read-only discussions. Like what you see? Join the Club to get full Q&A privileges. If this is your first visit, be sure to check out our FAQ page.  To start viewing messages, select the forum that you want to visit from the selection below.

Forum Jump

1 reply [Last post]
Former Member
Biggbhitter's picture
Huntington Station, NY
Offline
Joined: September 23rd, 2012

Posts:
18

Vehicles
1997 E300 Diesel

Is there a torque spec for the injectors? I imagine so, or just by "feel" to 2 grunt pounds or so
SLOWLY IT GOES! Waiting on the socket for the injectors now. I found 1 loose injector that showed signs of combustion leakage it was one of the cylinders I had to replace a pre-chamber in, though I left out the heat shield when I had the head off but its there, STRANGE! I didnt have the socket the last time and just used the flats on the top of the injector to tighten it with a crows foot, not sure what to make of it so I wait for the correct tool now
Thanks

Share this
__________________

1997 E300D

Guest
Stygimoloch's picture
Offline

Posts:
533
40nm/30lb-ft

40nm/30lb-ft

__________________

AKA, ForcedInduction. ASE certified master technician.
1982 300D Holset HE221W turbo, 7mm M-Pump, A/W intercooler, W/M injection
1980 240D 3.0T OM617a, 4-speed manual, 3.07 diff

Forum Jump

Share this