not-front-rule

W210 Sirius Antenna lead- run to roof above rear window glass

Welcome to the Mercedes-Benz Club of America Forums
Here, you'll find members en masse who can talk, guide, answer or listen to your Mercedes-Benz related questions and comments. Participation in the forums is free to Club members. If you're a guest of this site, you'll have access to our read-only discussions. Like what you see? Join the Club to get full Q&A privileges. If this is your first visit, be sure to check out our FAQ page.  To start viewing messages, select the forum that you want to visit from the selection below.

Forum Jump

No replies
Member
itsagaas's picture
Stewartsville, NJ
Offline
Joined: June 3rd, 1998

Posts:
12

Vehicles
2014 E250 BlueTEC
2009 ML350
1999 E300 Turbo Diesel

Question is about a 1999 E300 Turbodiesel (W210) - I am soon going to install the Sirius radio kit that I recently received as a gift. Instructions are to run the antenna lead inside the car along the upper edge of the rear window and through the seal along the upper edge of the rear glass. Does the moulding strip around the glass have to come off to do this? If so, what is the best technique to remove the moulding while leaving it in a condition that it can be reinstalled without leakage around the perimeter of the glass.
Thank you,
Ken
   

Share this
__________________

1999 E300 Turbodiesel (348k miles)
2009 ML350

2014 E250 Bluetec
2005 SLK350 (sold)
1998 ML320 (sold)
1991 E300 2.5 Turbodiesel (sold)


Forum Jump

Share this